ATD-8696 4 IN 1 BALL JOINT SERVICE TOOL SET WARNING: TO HELP PREVENT PERSONAL INJURY Always wear ANSI approved goggles when using this produc
Disassembly 1. Remove any external and/or internal lock rings. 2. Position the C-frame press around the drive shaft yoke, and tighten the forcing sc
refer to Figure 3. 2. Tighten the forcing screw until the receiving tube contacts the control arm. Check the alignment of all tooling and components,
Item# Ordering Part# Description1 PRT8696-1 SCREW2 PRT8696-2 BLOW MOLDED CASE3 PRT8696-3 INSTALL ADAPTER4 PRT8696-4 INSTALL CUP ADAPTER5 PRT8696-5 REC
Commentaires sur ces manuels