ATD Tools ATD-8696 Manuel d'utilisateur télécharger pdf (Page 2)

Disassembly

1. Remove any external and/or internal lock rings.

2. Position the C-frame press around the drive shaft yoke, and tighten the forcing screw

until the first bearing is removed.

3. Reposition the C-frame and remove the second bearing.

Assembly

1. Clean all dirt and oil from the yoke area.

2. Align the replacement bearing and C-frame press as straight as possible over the

yoke. Press the replacement bearing into the yoke, and reassemble the external /

internal lock ring.

3. Reposition the C-frame press and second replacement bearing as straight as

possible over the yoke, and press the bearing into the yoke. Reassemble the external

/ internal lock ring.

Ball Joint Removal and Installation

This tool set is designed for use on all cars and light trucks that have press-fit type ball

joints without the need to remove the control arm from the vehicle.

NOTE: Some cars and light trucks may have the upper ball joint spot-welded to the

control arm. The weld must be cut before attempting to remove the ball joint.

Removal

1. Assemble the ball joint press over the control arm as shown in Figure 3. Select the

correct size receiving tube (Item 6, 7, or 8), and position it under the vehicle ball joint

1 2 3 4

Pas de commentaire

ATD Tools ATD-8696 Manuel d'utilisateur Page 2